Snmp-Server Enable Server - HP procurve 420 Management And Configuration Manual

Related Commands
snmp-server location (page 6-29)

snmp-server enable server

This command enables SNMP management access and also enables this
device to send SNMP traps (i.e., notifications). Use the no form to disable
SNMP service and trap messages.
Syntax
snmp-server enable server
no snmp-server enable server
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• This command enables both authentication failure notifications and
link up-down notifications.
The snmp-server host command specifies the host device that will
•
receive SNMP notifications.
Example
HP420(config)#snmp-server enable server
HP420(config)#
Related Commands
snmp-server host (page 6-28)
Command Line Reference
SNMP Commands
6-27