Cli: Configuring Wpa Settings - HP procurve 420 Management And Configuration Manual
Hide thumbs
Also See for procurve 420:
- Management and configuration manual (257 pages) ,
- Getting started manual (94 pages) ,
- Installation and getting started manual (78 pages)
Table of Contents
Advertisement
Access Point Configuration
Configuring Wireless Security
Figure 5-12. WPA Settings Window
5-60
CLI: Configuring WPA Settings
CLI Commands Used in This Section
Command Syntax
interface <ethernet | wireless g>
authentication <open | shared>
[no] encryption <key-length>
[no] 802.1x <supported | required>
wpa-clients <required | supported>
wpa-mode <dynamic | pre-shared-key>
CLI Reference Page
page 6-53
page 6-67
page 6-68
page 6-40
page 6-74
page 6-75
Advertisement
Table of Contents
Need help?
Do you have a question about the procurve 420 and is the answer not in the manual?
Questions and answers