Mast Rotation Continuous System - Nacra F18 Evolution Assembly Manual

1.8 Mast rotation continuous system

1. Tie the two 16mm blocks on both sides on the loops
underneath the trampoline.
2. Attach the shockcord (blue) by making a bowline to
the loop at the port side.
3. Take the loose end of the shockcord and feed it
through the 16mm block on starboard side. Attach
the 16mm block on the end of the shockcord with a
bowline.
4. Fixate the line (orange) on the starboard side in the
rear camcleat and feed it between the trampoline
and the tramp lace underneath the trampoline. Pull
it upwards through the big eyelet in the middle.
5. Feed the line through the Harken lead ring and
return it down below through the same eyelet
towards the port side.
6. Feed it between the trampoline and tramp lace
and feed the line through the rear camcleat. And
through the ring.
Go from the front to the back through both of
the 16mm block so that the line does not cross.
7. Feed it between the trampoline and the tramp
lace underneath the trampoline, continue through
the 16mm block (attached to the shockcord) on
starboard side and feed it back through the fixated
16mm block on port side.
8. Finally pull the line towards the starboard side and
feed it between the trampoline and the tramp lace.
Then feed the line through the ring.
9. Attach both ends to each other as shown in photo A
with two bowlines.
10. Adjust the connection to locate it inside the
trampoline.
12