Table of Contents
Advertisement
2.6.
Fixing the stays
Tools needed:
- Long nose plier
- Self-amalgamating tape
1.
Use the shackle 8mm 5/16, 2 nylon washers, the shrouds
and forestay.
2.
Install them as shown in the picture. The forestay must be
located in the middle.
3.
Tape the crimp sleeves of the forestay.
•
Make sure the eye of the forestay is facing
the mast!
•
Tighten the shackle firmly with a long nose
plier!
4.
Secure the shackle using the last Monel wire piece.
28.
8mm 5/16
5.
Tape the monel wire piece using the self amalgamating
tape.
Cut the excess wire and bend it back through the hole
of the shackle pin before taping it!
•
Check for sharp edges and tape them if
necessary!
2x
2x
Advertisement
Table of Contents
