Spinnaker Blocks; Trapeze Shockcord; Spinnaker Sheet Rings; Spinnaker Halyard Rings - Nacra F18 Evolution Assembly Manual

1.4 Spinnaker blocks

1. Attach the four 29mm carbo single fixed
assymetric blocks on the right positions as
shown in the picture.
2. Attach the two carbo 40mm single/swivel blocks
to the loops on both sides located at the front of
the trampoline.

1.5 Trapeze shockcord

1. Knot a loop in the trapeze shockcord and feed
the other end through the fairlead.
2. Pull the shockcord underneath the trampoline
to the other side.
3. Feed the shockcord through the fairlead and
knot a loop.

1.6 Spinnaker sheet rings

1. Tie a 15mm ring to the end of the shockcord.
2. Feed the shockcord through the eyelet from
above and pull the shockcord to the other side
and feed it through the eyelet from below.
3. Attach a 15 mm ring to the end of the shockcord.

1.7 Spinnaker halyard rings

1. Tie a 15mm ring to the end of the shockcord.
2. Feed the shockcord through the eyelet from
above and pull the shockcord underneath the
rear crossbar to the last tramp button.
3. Attach the shockcord with a bowline on the
tramp lace rear.
10