Mitsubishi Lancer Evolution Owner's Manual page 97

Instruments and controls
Odometer
The odometer indicates the distance travelled.
Tripmeter
The tripmeter indicates the distance travelled be-
tween two points.
Example usage of tripmeter and tripmeter
It is possible to measure two currently travel-
led distances, from home using tripmeter
and from a particular point on the way using
tripmeter .
To reset the tripmeter
To return the display to 0, hold down the multi-in-
3
formation meter switch for about 2 seconds or
more. Only the currently displayed value will be re-
set.
Example
If tripmeter is displayed, only tripmeter
will be reset.
3-06
NOTE
l
If there is no warning display, the switching
sequence is: Odometer/Tripmeter
ometer/Tripmeter → Service reminder
→ Odometer/Tripmeter .
l
Both tripmeters and can count up to
9999.9 km (9999.9 miles).
When a tripmeter goes past 9999.9 km
(9999.9 miles), it returns to 0.0 km
(0.0 miles).
l
When disconnecting the battery terminal, the
memories of tripmeter display and dis-
play are erased, and their displays return
to 0.0 km (0.0 miles).
Service reminder
E00521300901
This displays the distance and number of
months until the next periodic inspection.
Refer to "Service reminder" on page
3-13
Interrupt display screen (when the ig-
nition switch is "OFF")
E00520500704
When there is information to be announced, such
as lamp reminders, the buzzer sounds and the multi-
information display switches to the warning dis-
play screen. Refer to the appropriate page and take
the necessary measures.
When the cause of the warning display is elimina-
ted, the warning display goes out automatically.
OGEE12E1
Refer to "Warning display list (when the ignition
switch is "OFF")" on page 3-24.
→ Od-
1- Information generated
2- Cause eliminated
To return to the screen displayed before the warn-
ing display
Even if the cause of the warning display is not elim-
inated, you can return to the screen that was dis-
played before the warning display.
If you press the multi-information meter switch,
the display screen switches to the screen that was
displayed before the warning display and the "!"
mark (A) is displayed.