Mitsubishi Lancer Evolution Owner's Manual page 33

Locking and unlocking
Refer to "Locking and unlocking: Doors, Central
door locks" on pages 1-22 and 1-23.
1
NOTE
l For vehicles equipped with the mirror retrac-
tor switch, the outside rear-view mirrors auto-
matically extend when all the doors are un-
locked using the keyless operation function.
Refer to "Starting and driving: Outside rear-
view mirrors" on page 4-07.
l For vehicles equipped with the central door
lock switch, the keyless operation function
can be set so that only the driver's door un-
locks when the driver's door lock/unlock
switch is pressed.
If the keyless operation function is set to
work as described above, all the doors un-
lock when the driver's door lock/unlock
switch is pressed two times in succession.
Refer to "Setting of door unlock function"
on page 1-21.
l
The keyless operation function does not oper-
ate under the following conditions:
• A door is open or ajar.
1-10
• The ignition switch is not in the "LOCK"
position.
• The emergency key is in the ignition
switch.
l The time between unlocking and automatic
locking can be adjusted. Please consult a
MITSUBISHI MOTORS Authorized Service
Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the ad-
justment. Refer to the separate owner's man-
ual for details.
Operation confirmation when locking and un-
locking
Operation can be confirmed as shown below. How-
ever, the room lamp will illuminate only if the
front room lamp switch is in the "DOOR" position
or the rear room lamp switch (except in a vehicle
with a sunroof) is in the middle (•) position.
When locking: The turn-signal lamps
blink once.
When unlocking: The room lamp illumi-
nates for about 15 sec-
onds and the turn-sig-
nal lamps blink twice.
NOTE
l Functions can be modified as stated below.
For further information, please contact your
MITSUBISHI MOTORS Authorized Service
Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the ad-
OGEE12E1
justment. Refer to the separate owner's man-
ual for details.
• Activating the operation confirmation
function (blinking of the turn-signal
lamps) only during locking, or only dur-
ing unlocking.
• Disabling the operation confirmation func-
tion (blinking of the turn-signal lamps).
• Changing the number of blinks for the op-
eration confirmation function (blinking
of the turn-signal lamps).
Operation of the Dead Lock System
With a vehicle that has a Dead Lock System, it is
possible to set the Dead Lock System using the driv-
er's or front passenger's door lock/open switch.
(Refer to "Dead Lock System" on page 1-25.)
To open the trunk lid
While carrying the keyless operation key within
the operating range to open the trunk lid, press and
hold down the OPEN switch (A) until the trunk lid
opens.
Also refer to "Trunk lid" on page 1-27.