Mitsubishi Lancer Evolution Owner's Manual page 101

Instruments and controls
l When the ignition switch is switch-
ed from "ACC" or "LOCK" to
"ON", the mode setting is automat-
ically switched from manual to au-
to.
Switching to auto occurs automati-
cally.
If switching to manual mode is
done, however, the data from the
last reset is displayed.
Auto reset mode
l When the average speed is being
displayed, if you hold down the
multi-information meter switch,
3
the average speed displayed at that
time is reset.
l If the ignition switch is at "ACC"
or "LOCK" for about 4 hours or
longer, the average speed display
is automatically reset.
NOTE
l The average speed display and the
average fuel consumption display
can be reset separately in both au-
to reset mode and manual reset
mode.
l "---" is displayed when the aver-
age speed cannot be measured.
l The initial (default) setting is "Au-
to reset mode".
3-10
l The display setting can
changed to the preferred units
(km/h or mph).
Refer to "Changing the function
settings (when the ignition switch
is "ON")" on page 3-15.
l The average speed display memo-
ries for auto reset mode and man-
ual reset mode are erased if the bat-
tery is disconnected.
Average fuel consumption display
E00521700732
This displays the average fuel consumption from
the last reset to the present time.
There are the following 2 mode settings.
For information on how to change the average fuel
consumption display setting, refer to "Changing
the function settings (when the ignition switch is
"ON")" on page 3-15.
OGEE12E1
be
The " " mark (A) in the momentary fuel gauge
shows the average fuel consumption.
Manual reset mode
l When the average fuel consumption is being
displayed, if you hold down the multi-infor-
mation meter switch, the average fuel con-
sumption displayed at that time is reset.
l When the ignition switch is switched from
"ACC" or "LOCK" to "ON", the mode set-
ting is automatically switched from manual
to auto.
Switching to auto occurs automatically. If
switching to manual mode is done, however,
the data from the last reset is displayed.
Auto reset mode
l When the average fuel consumption is being
displayed, if you hold down the multi-infor-
mation meter switch, the average fuel con-
sumption displayed at that time is reset.
l If the ignition switch is at "ACC" or
"LOCK" for about 4 hours or longer, the aver-
age fuel consumption display is automatical-
ly reset.
NOTE
l The average speed display and the average
fuel consumption display can be reset sepa-
rately in both auto reset mode and manual re-
set mode.
l
"---" is displayed when the average fuel con-
sumption cannot be measured.
l The initial (default) setting is "Auto reset
mode".