Mitsubishi Lancer Evolution Owner's Manual page 131

Instruments and controls
Welcome light
This function turns on the position and tail lamps
for about 30 seconds after the UNLOCK switch
(A) on the remote control transmitter is pressed
when the combination headlamps and dipper
switch is in the "OFF" or "AUTO" position. The
welcome light function will operate only when it is
dark outside the vehicle.
3
NOTE
l While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK switch (B) on the remote
control transmitter.
3-40
E00528900355
• Turn the combination headlamps and dip-
per switch to the "
• Turn the ignition switch to the "ON" po-
sition.
l It is possible to modify functions as follows:
• The headlamps can be set to come on in
the low beam setting.
• The welcome light function can be deacti-
vated.
For further information, please contact your
MITSUBISHI MOTORS Authorized Service
Point.
On vehicles equipped with MITSUBISHI
Multi-Communication
screen operations can be used to make the ad-
justment. Refer to the separate owner's man-
ual for details.
Coming home light
This function turns on the headlamps in the low
beam setting for about 30 seconds after the ignition
switch is turned to the "LOCK" position.
1. Turn the combination headlamps and dipper
switch to the "OFF" or "AUTO" position.
OGEE12E1
2. Turn the ignition switch to the "LOCK" posi-
tion. Also, if a key was used to start the en-
gine, remove the key from the ignition switch.
3. Within 60 seconds of turning the ignition
switch to the "LOCK" position, pull the turn
signal lever towards you.
" or " " position.
4. The headlamps will come on in the low
beam setting for about 30 seconds. After the
headlamps go off, the headlamps can be
turned on again in the low beam setting for
about 30 seconds by pulling the turn signal
lever towards you within 60 seconds of turn-
System (MMCS),
ing the ignition switch to the "LOCK" posi-
tion. To turn on the headlamps again after 60
seconds of turning the ignition switch to the
"LOCK" position, repeat the process from
step 1.
NOTE
E00529000337
l While the coming home light function is op-
erating, perform one of the following opera-
tions to cancel the function.
• Pull the turn signal lever towards you.