Mitsubishi Lancer Evolution Owner's Manual page 44

• The indication lamp (4) is dim or does
not come on.
For further information, please consult
your MITSUBISHI MOTORS Author-
ized Service Point.
If you replace the battery yourself, refer
to "Procedure for replacing the remote
control switch battery" on page 1-21.
l
If your remote control switch is lost or dam-
aged, please contact your MITSUBISHI
MOTORS Authorized Service Point for a re-
placement remote control switch.
l If you wish to add remote control switch,
please contact your MITSUBISHI MOTORS
Authorized Service Point. A maximum of 4
remote control switches are available for
your vehicle.
Setting of door unlock function (vehicles equip-
ped with the central door lock switch)
E00310400102
The door unlock function can be set to the follow-
ing two conditions.
Each time the door unlock function is set, a chime
will sound to tell you the condition of the door un-
lock function.
Number of
Condition
chimes
One chime All doors unlock
Two chimes Driver's door unlock only
1. Turn the ignition switch to the "LOCK" posi-
tion. If you started the engine with the key,
remove the key from the ignition switch.
2. Place the combination headlamps and dipper
switch in the "OFF" position, and leave the
driver's door open.
3. Press the LOCK switch (1) for 4 to 10 sec-
onds and press the UNLOCK switch (2) dur-
ing this time.
4. Release in sequence the LOCK and UN-
LOCK switches within 10 seconds of press-
ing the LOCK switch in step 3.
NOTE
l On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the ad-
justment. Refer to the separate owner's man-
ual for details.
Procedure for replacing the remote control switch
battery
E00309600016
1. Before replacing the battery, remove static
electricity from your body by touching a met-
al grounded object.
2. With the MITSUBISHI mark facing you, in-
sert the cloth-covered tip of a straight blade
(or minus) screwdriver into the notch in the
case and use it to open the case.
OGEE12E1
Locking and unlocking
NOTE
l Be sure to perform the procedure with the
MITSUBISHI mark facing you. If the
MITSUBISHI mark is not facing you when
you open the case, the transmitter may come
out.
3. Remove the old battery.
4. Install a new battery with the + side (A) up.
+ side
- side
Coin type battery
CR2032
5. Close the case firmly.
6. Check the keyless operation function to see
that it works.
NOTE
l You may purchase a replacement battery at
an electric appliance store.
l A MITSUBISHI MOTORS Authorized Serv-
ice Point can replace the battery for you if
you prefer.
1
1-21