Mitsubishi Lancer Evolution Owner's Manual page 254

4. The voice guide will say "Password is disa-
bled. Would you like to enable it?" Answer
"Yes."
Answer "No" to cancel the setting of the pass-
word and return to the main menu.
5. The voice guide will say "Please say a 4-dig-
it password. Remember this password. It will
be required to use this system."
Say a 4-digit number which you want to set
as a password.
6. For confirmation purposes, the voice guide
will say "Password <4-digit password>. Is
this correct?" Answer "Yes."
Answer "No" to return to the password input
in Step 5.
7. When the registration of the password is com-
pleted, the voice guide will say "Password is
enabled" and the system will return to the
main menu.
NOTE
l Password will be required to access the sys-
tem after the next ignition cycle.
l It is required for a little time after engine
stop that the entered password is actually re-
corded in the system.
If the ignition switch is made to "ACC" or
"ON" or the engine is started immediately af-
ter engine stop, there is a case when the en-
tered password is not recorded in the system.
At this time, please try to enter the password
again.
Entering the password
If a password has been set and the security function
is enabled, the voice guide will say "Hands-free sys-
tem is locked. State the password to continue"
when the SPEECH button is pressed to enter voice
recognition mode. Say the 4-digit password num-
ber to enter the password.
If the entered password is wrong, the voice guide
will say "<4- digit password>, Incorrect password.
Please try again." Enter the correct password.
NOTE
l You can reenter the password as many times
as you want.
l If you have forgotten your password, say
"Cancel" to quit the voice input mode and
then check with a MITSUBISHI MOTORS
Authorized Service Point.
Disabling the password
Use the following procedure to turn off the security
function by disabling the password.
NOTE
l
System must be unlocked to disable the pass-
word.
1. Press the SPEECH button.
2. Say "Setup."
3. Say "Password."
4. The voice guide will say "Password is ena-
bled. Would you like to disable it?" Answer
"Yes."
Answer "No" to cancel the disabling of the
password and return to the main menu.
OGEE12E1
For pleasant driving
5. When the disabling of the password is com-
pleted, the voice guide will say "Password is
disabled" and the system will return to the
main menu.
Speaker enrollment function
E00727400209
®
The Bluetooth 2.0 interface can use the speaker en-
rollment function to create a voice model for one
person per language.
®
This makes it easier for the Bluetooth 2.0 inter-
face to recognise voice commands said by you.
You can turn a voice model registered with the
speaker enrollment function on and off whenever
you want.
Speaker enrollment
E00727500213
It takes about 2 to 3 minutes to complete the speak-
er enrollment process.
To ensure the best results, run through the process
while in the driver's seat, in an environment that is
as quiet as possible (when there is no rain or strong
winds and the vehicle windows are closed). Please
turn off your phone while in speaker enrollment to
prevent interruption of the process.
Use the following procedure for speaker enrollment.
1. Stop your vehicle in a safe area, put the gear-
shift lever in the "N" (Neutral) position
(M/T), or the gearshift lever in the "P"
(PARK) position (Twin Clutch SST), and
pull the parking brake lever.
NOTE
l Speaker enrollment is not possible unless the
vehicle is parked. Make sure you park the ve-
hicle in a safe area before attempting speaker
enrollment.
5
5-67