Mitsubishi Lancer Evolution VII Manual
  1. Manuals
  2. Brands
  3. Mitsubishi Manuals
  4. Automobile
  5. Lancer Evolution VII
  6. Manual

Mitsubishi Lancer Evolution VII Manual

Exterior
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

General .......................................................1
Front bumper ...........................................2
Adhesives ................................................2
Front bumper ..........................................2

GENERAL

New servicing information now applies with the following changes and additions. Apart from the information below, servicing is
the same as the Lancer Evolution VII.
• Changes in the shape of the front bumper and addition of new components
• Addition of components due to changes in rear spoiler shape, and change in the positioning of double-sided adhesive tape
• Change in the shape of three diamond mark, EVOLUTION mark and LANCER mark, and change in the positioning of
EVOLUTION mark and LANCER mark.
EXTERIOR - GENERAL
SECTION 51
EXTERIOR
CONTENTS
Rear spoiler ...............................................4
Marks ..........................................................6
Adhesive .................................................4
Rear spoiler ............................................5
51-1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Lancer Evolution VII and is the answer not in the manual?

Questions and answers

Related Manuals for Mitsubishi Lancer Evolution VII

Summary of Contents for Mitsubishi Lancer Evolution VII

  • Page 1 GENERAL New servicing information now applies with the following changes and additions. Apart from the information below, servicing is the same as the Lancer Evolution VII. • Changes in the shape of the front bumper and addition of new components •...
  • Page 2 51-2 EXTERIOR – FRONT BUMPER Front Bumper Adhesive Application Brand Three Diamond Mark Double-sided tape: Generic product (width 20 mm, thickness 0.8 mm) Front bumper Removal and Installation Section A-A clip Section B-B clip Section C-C clip fender Removal procedure •...
  • Page 3 EXTERIOR – FRONT BUMPER 51-3 Disassembly and Reassembly Double-sided tape: Generic tape Width: 20 mm; Thickness 0.8 mm Section B-B Section A-A Clip Clip...

  • Page 4: Rear Spoiler

    51-4 EXTERIOR – FRONT BUMPER, REAR SPOILER Disassembly Procedure 10. Bumper net 1. Three diamond mark 11. Front bumper side cover 2. Licence plate trim 12. Bumper side net (LH) 3. Licence plate bracket 13. Oil cooler duct 4. Licence plate bracket assembly 14.
  • Page 5 EXTERIOR – REAR SPOILER 51-5 Rear Spoiler Removal and Installation Double-sided tape: Generic products A: width 5 mm, thickness 0.8 mm, B: width 5 mm, thickness 1.2 mm Primer: Sumitomo 3M 8107 PP parts primer Removal procedure • Boot lid bumper 1.
  • Page 6 51-6 EXTERIOR – MARKS Marks Removal and Installation 3. EVOLUTION mark 1. Three diamond mark 2. LANCER mark Installation service points Installation of marks 1. Installation position (2) LANCER mark Boot lid end line Boot lid end line...
  • Page 7 EXTERIOR – MARKS 51-7 (3) EVOLUTION mark Boot lid end line Boot lid end line 2. Installation procedure (1) Remove grease from installation surface of the body, using unleaded gasoline. (2) Peel off the protective backing of the mark and apply it to the installation position.

Table of Contents