Rear Seat; Head Restraints (Rear Seat Only) - Mitsubishi Lancer Evolution Owner's Manual

Rear seat

E00401300018
Armrest
E00401700517
To use the armrest, fold it down.
To return to the original position, push it backward
until it is flush with the seat.
NOTE
l The top surface of the armrest contains a cup
holder for rear seat occupants.
Refer to "Cup holder" on page 5-89.

Head restraints (Rear seat only)

E00403301035
WARNING
l Driving without the head restraints in
place can cause your passengers serious
injury or death in an accident. To reduce
the risk of injury in an accident, always
make sure the head restraints are instal-
led and properly positioned when the seat
is occupied.
l Never place a cushion or similar device
on the seatback. This can adversely affect
head restraint performance by increasing
the distance between passenger's head
and the restraint.
To adjust height
Adjust the head restraint height so that the centre
of the restraint is as close as possible to eye level to
reduce the chances of injury in the event of colli-
sion. Any person too tall for the restraint to reach
their seated eye level, should adjust the restraint as
high as possible.
OGEE12E1
Seat and seat belts
To raise the head restraint, move it upward. To low-
er the restraint, move it downward while pushing
the height adjusting knob (A) in the direction of the
arrow. After adjustment, push the head restraint
downward and make sure that it is locked.
To remove
Lift the head restraint with the height adjusting
knob (A) pushed in.
2
2-05