Mitsubishi Lancer Evolution Owner's Manual page 182

To deactivate
E00609700720
The set speed driving can be deactivated as follows:
l Press the "ON OFF" switch (A) (Cruise con-
trol will be turned off.)
l Press the "CANCEL" switch (D).
l Depress the brake pedal.
The set speed driving is deactivated automatically
in any of the following ways.
l When you depress the clutch pedal (on vehi-
cles with M/T).
l When your speed slows to about 15 km/h
(9 mph) or more below the set speed because
of a hill, etc.
l When your speed slows to about 40 km/h
(25 mph) or less.
l When the Twin Clutch SST control mode is
set to "Sport" mode (on vehicles with Twin
Clutch SST).
Refer to "Twin Clutch SST control mode"
on page 4-19.
l When the Active Stability Control (ASC)
starts operating.
Refer to "Active stability control (ASC)" on
page 4-34.
WARNING
l On vehicles with Twin Clutch SST, al-
though the set speed driving will be deac-
tivated when shifting to the "N" (NEU-
TRAL) position, never move the gearshift
lever to the "N" (NEUTRAL) position
while driving.
You would have no engine braking and
could cause a serious accident.
Also, the set speed driving may be deactivated as
follow:
l
When the engine speed rises and approaches
the tachometer's red zone (the red-coloured
part of the tachometer dial).
CAUTION
l When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the "ON OFF" switch to turn off
the cruise control and have your vehicle
inspected by a MITSUBISHI MOTORS
Authorized Service Point.
OGEE12E1
Starting and driving
To resume the set speed
E00609800486
If the set speed driving is deactivated by the condi-
tion described in "To deactivate" on page 4-41,
you can resume the previously set speed by press-
ing the "ACC RES" switch (C) while driving at a
speed of about 40 km/h (25 mph) or higher.
Under either of the following conditions, however,
using the switch does not allow you to resume the
previously set speed. In these situations, repeat the
speed setting procedure:
l The "ON OFF" switch is pressed.
l The ignition switch is turned OFF.
l "CRUISE" indication lamp is turned OFF.
4
4-41