Mitsubishi Lancer Evolution Owner's Manual page 221

For pleasant driving
To listen to a CD
The CD can be loaded or ejected by pressing the
LOAD button (5) or the eject button (15) even if
the audio system power is off.
1. Press the PWR switch (3) to turn the audio
system ON and OFF. The audio system turns
on in the last mode used.
2. Press the CD button (2) to enter CD mode.
The autochanger will start playback if the
CD is already in the autochanger.
3. To stop the CD, turn off the power by press-
ing the PWR switch (3) or change over to ra-
dio mode by pressing the AM/FM button (1),
or eject the disc by pressing the eject button
(15).
NOTE
l For information on adjusting the volume and
tone, refer to "To adjust the volume" on page
5-24 and "To adjust the volume" on page
5-24.
5
l
As many as 6 CDs can be inserted into the
CD autochanger.
l 8 cm CDs cannot be played on this autoch-
anger.
l For information concerning the handling of
compact discs, refer to "Handling of compact
discs" on page 5-60.
5-34
To set discs
E00709601987
To set a single disc
1. Press the LOAD button (5) briefly.
2. The autochanger will show "WAIT" on the
display and start making itself ready for disc
loading.
3. When the autochanger is ready for disc load-
ing, the LOAD indicator (4) will illuminate
and the display will show "LOAD DISC No.
(1-6)".
4. When a disc is inserted into the CD slot, the
disc will begin to play.
NOTE
l If there are multiple empty slots, you can se-
lect your desired slot by pressing the DISC
buttons (12 or 13).
l If you do not insert a disc for about 15 sec-
onds after the autochanger starts standing by
for loading, the loading standby mode will
be cancelled.
To set all the discs
1. Press the LOAD button (5) for 2 seconds or
longer (until you hear a beep).
OGEE12E1
2. The autochanger will select the lowest-num-
bered empty slot and switch to loading stand-
by mode.
3. When the display shows "LOAD DISC No.
(1-6)" insert a disc. The autochanger will
then automatically select the next empty slot
and enter loading standby mode.
4. Repeat the above-described steps until every
slot contains a disc. Playback will then begin
with the disc that you inserted last.
NOTE
l If you press the LOAD button (5) again
while the autochanger is in loading standby
mode, the loading standby mode will be can-
celled.
To eject discs
To eject a single disc
Press the eject button (15) briefly to eject the cur-
rently selected disc.