Mitsubishi Lancer Evolution Owner's Manual page 129

Instruments and controls
OFF All lamps off
With the ignition switch in the
"ON" position, headlamps, posi-
tion, tail, licence plate, and in-
strument panel lamps turn on
AUTO and off automatically in accord-
ance with outside light level.
All lamps turn off automatically
when the ignition switch is
turned to "OFF" position.
Position, tail, licence plate and
instrument panel lamps on
Headlamps and other lamps go
3 on
NOTE
l The sensitivity of the automatic on/off con-
trol can be adjusted.
For further information,
MITSUBISHI MOTORS Authorized Service
Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System
screen operations can be used to make the ad-
justment.
Refer to the separate owner's manual for de-
tails.
3-38
l When the headlamps are turned off by the au-
tomatic on/off control with the ignition
switch in the "ON" position, the front fog
lamps and rear fog lamp also go off. When
the headlamps are subsequently turned back
on by the automatic on/off control, the front
fog lamps also come on but the rear fog lamp
stay off. If you wish to turn the rear fog lamp
back on, operate the switch again.
l
Do not cover the sensor (A) for the automat-
ic on/off control by affixing a sticker or label
to the windscreen.
contact a
(MMCS),
l If the lamps do not turn on or off with the
switch in the "AUTO" position, manually op-
erate the switch and we recommend you to
have your vehicle checked.
Vehicles with Daytime Running Lamp*
When the engine is running and the lamp switch is
set to the "AUTO" or "OFF" position, the low
beam of the headlamps, tail lamp etc., will illumi-
nate.
OGEE12E1
NOTE
l
The daytime running lamp can be deactivated.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Author-
ized Service Point.
The regulations concerning daytime running
lamp may differ from country to country.
Find out and follow the laws and regulations
in driving area.
Lamps (headlamps, fog lamp, etc.) au-
to-cutout function
E00532700051
l
If, while the lamp switch is in the "
tion, the ignition switch is turned to the
"LOCK" position or "ACC" position, or the
key is removed from the ignition switch, the
lamps automatically go out when the driver's
door is opened.
[When the engine was started using the key]
• If the key is removed and the driver's
door is opened, a buzzer sounds at a high
pitch intermittently to remind the driver
to turn off the lamps.
[When the engine was started using the key-
less operation function]
• If the ignition switch is turned to the
"LOCK" position and the driver's door is
opened, a buzzer sounds at a high pitch in-
termittently to remind the driver to turn
off the lamps.
" posi-