Mitsubishi Lancer Evolution Owner's Manual page 56

To activate the function again, raise and hold the
wiper and washer switch to the "MIST" position
for approximately 3 seconds.
The buzzer will sound twice and the function will
be activated.
NOTE
l The function will be activated again if the fol-
lowing operation is performed.
• If the doors are unlocked using the key-
less entry system or the keyless operation
function.
• If the ignition switch is turned to the
"ON" or "ACC" position.
Cancelling the system
E00301800591
The following methods can be used to cancel the
system when it is in the system preparation mode
or the system armed mode.
l Pressing the UNLOCK switch on the remote
control switch.
l Turning the ignition switch to the "ON" posi-
tion.
l Opening any one of the doors, or inserting
the key into the ignition switch when the sys-
tem is in the system preparation mode.
l Holding the keyless operation key and press-
ing the driver's or front passenger's door lock/
unlock switch to unlock the doors (vehicles
equipped with the keyless operation system).
NOTE
l If the bonnet or the trunk lid is opened dur-
ing the system preparation mode, the system
preparation mode is suspended.
The system returns to the system preparation
mode when the bonnet or the trunk lid is
closed.
l If the battery terminals are disconnected
while the system is in the system preparation
mode, the memory will be erased.
l It is possible to register up to 8 remote con-
trol switches for keyless entry system and 4
remote control switches for keyless operation
system.
As long as they are registered, any of the re-
mote control switches, other than the one
used to activate the system, can be used to
cancel the system.
If you want to register additional remote con-
trol switches, please contact
MITSUBISHI MOTORS Authorized Service
Point.
OGEE12E1
Locking and unlocking
l The activation distance for keyless entry sys-
tem is approximately 4 m.
If it is not possible to lock or unlock the vehi-
cle by pressing the switch at the correct dis-
tance or the security alarm system cannot be
set or cancelled using the switch, the battery
may need to be replaced.
Replace the battery at your MITSUBISHI
MOTORS Authorized Service Point.
l
If the UNLOCK switch on the remote con-
trol switch, or the driver's or front passen-
ger's door lock/unlock switch is pressed and
no door is opened within 30 seconds, the
doors will automatically relock. In this case
as well, the system preparation mode will go
into effect.
l The time between pressing the UNLOCK
switch on the remote control switch, or the
driver's or front passenger's door lock/un-
lock switch and automatic locking can be ad-
justed. Please consult your MITSUBISHI
MOTORS Authorized Service Point for de-
tails.
On vehicles equipped with MITSUBISHI
Multi-Communication System
screen operations can be used to make the ad-
justment. Refer to the separate owner's man-
ual for details.
your
Alarm activation
When the system is in the system armed mode, the
alarm will be activated as follows if the vehicle is
unlocked or if any of the doors, trunk lid or bonnet
is opened using a method other than the keyless en-
try system or the keyless operation function.
1. The inside alarm will be activated for approx-
imately 10 seconds. (except for vehicles
equipped with the interior alarm sensor)
1
(MMCS),
E00301900736
1-33