Mitsubishi Lancer Evolution Owner's Manual page 111

Instruments and controls
4. Lightly press the multi-information meter
switch to select the time until the display.
5. Press and hold the multi-information meter
switch for about 2 seconds or more, the set-
ting is changed to the selected time.
NOTE
l If the battery is disconnected, the unit setting
is erased from memory and is automatically
set to OFF.
l The drive time is reset when the ignition
switch is turned off.
Changing the turn-signal sound
3
It is possible to change the turn-signal sound.
1. Press and hold the multi-information meter
switch for about 2 seconds or more to switch
from the setting mode screen to the menu
screen.
Refer to "Changing function settings (when
the ignition switch is "ON")" on page 3-15.
2. Lightly press the multi-information meter
switch to select (changing the turn-sig-
nal sound).
3-20
3. Press and hold the multi-information meter
switch for about 2 seconds or more to switch
in sequence from 1 (turn-signal sound 1) →
2 (turn-signal sound 2) → 1 (turn-signal
sound 1).
The setting changes to the selected turn-sig-
nal sound.
Changing the momentary fuel consumption display
It is possible to change the bar graph setting of the
momentary fuel consumption display.
1. Press and hold the multi-information meter
switch for about 2 seconds or more to switch
from the setting mode screen to the menu
E00529100312
screen.
Refer to "Changing the function settings
(when the ignition switch is "ON")" on page
3-15.
2. Lightly press the multi-information meter
switch to select (changing the momenta-
ry fuel consumption display).
OGEE12E1
3. Press and hold the multi-information meter
switch for about 2 seconds or more to switch
in sequence from ON (with the green bar
graph) → OFF (without the green bar graph)
→ ON (with the green bar graph).
The setting changes to the selected bar graph
setting.
Returning to the factory settings
E00529200241
All of the function settings can be returned to their
factory settings.
1. Press and hold the multi-information meter
switch for about 2 seconds or more to switch
from the setting mode screen to the menu
screen.
Refer to "Changing the function settings
(when the ignition switch is "ON")" on page
3-15.
2. Lightly press the multi-information meter
switch to select "RESET" (returning to the
factory settings).
E00523600777