Setting The Print Offset For The Meter Imprint - FP Mailing Solutions ultimail Operator's Manual

13.4

Setting the print offset for the meter imprint

The print image normally appears always at the same distance from the right-hand
letter edge. In special cases, you can slide the meter imprint on the envelope to the
left away from standard position.
SET UP
SYSTEM SETTINGS
PRINT
You can adjust print offset in steps of
1 mm from 0 to maximum 50 mm.
Default setting is Zero (= no offset).
• Call SET UP menu with the
• Select SYSTEM SETTINGS
In the ADJUSTING PRINTING menu you
will see the current print offset setting.
How to adjust print offset:
• Type the desired offset (from 0 to
50 mm). The value appears at the right-
hand side of the status line.
• Assign the value with the key next to
PRINT OFFSET.
The print offset is set.
Caution! The meter imprint offset is
maintained until the next change, even if
you switch the ultimail off.
System settings 93
key.
PRINT.