FP Mailing Solutions ultimail Operator's Manual page 138

138 ultimail Operator Manual
Sponge
Checks:
Basket on the
extreme left
Basket
Cut-out
Sponge closely below the bars
(without protrusion)
Basket flushed on top
• Lift out of the water tray the basket with
the sponge. Remove sponge from
basket.
• Clean sponge or replace with a new
one.
• Put a new sponge into water before
inserting it, and let soak completely.
The flaps are thus correctly moistened
from the first letter on.
• Insert sponge in basket.
Sponge must be closely positioned to
the bars and rest on the lateral limit.
Ensure that sponge is not pressed by
the bars.
Two flaps on the longitudinal side hold
sponge to the basket.
• Insert basket with sponge into water
tray as shown in the figure. Mind the
position of the cut-out.
• Check if the basket is correctly seated:
It must rest on the extreme left in the
water tray and close on top in a flushed
manner.
• Insert the complete water tray into the
housing until it clicks into place.
• Check if the sponge is correctly seated.
It should be directly below the moist-
ening felt and brush.