Power And Input Connections - Extron electronics IN1604 DT User Manual

Power and Input Connections

IN1604 DTP
100-240V ~ 0.5 A MAX
Audio Plugs.eps
50-60 Hz
A
Figure 3.
Power connector — Connect the standard IEC power cord from a 100 to 240 VAC,
A
50-60 Hz power source into this connector. The front panel control and input selection
buttons light in sequence during power-up.
Configurable analog video connector — Connect a video source to the 15-pin HD
B
connector. It accepts RGB, YUV, S-video, and composite video (see
Wiring
HDMI input connectors — Connect video sources to the HDMI connectors.
C
TIP:
3.5 mm Stereo Plug Connector
(see
Analog audio input connector — Connect an audio source to the 3.5 mm
D
tip-ring-sleeve (TRS) connector for unbalanced analog audio.
3.5 mm Stereo Plug Connector
Figure 4.
Analog audio input connector — Connect an audio source to the 5-pole captive
E
screw connector. Wire the connector for line level, balanced or unbalanced, analog
stereo.
Tip
Ring
Sleeves
Tip
Ring
Figure 5.
1 CONFIGURABLE 2 HDMI 3 HDMI
4 HDMI
INPUT
Tip (+)
B C
Sleeve ( ) Power and Input Connectors (IN1604 DTP Shown)
RCA Connector
Tip (+)
Ring (-)
on page 11).
Sleeve ( )
Use Extron HDMI LockIt Lacing Brackets to secure HDMI cables to the device
HDMI Connections on page 11).
(balanced)
Tip (L)
Ring (R)
Sleeve ( )
(unbalanced)
TRS Wiring
Tip
Sleeve
Tip
Sleeve
Balanced Audio Input
Audio Input Connector Wiring
OUTPUT
OUT
L R
SIG LINK
L R
IN
HDBT
1 2
DTP
OUT
AUDIO
D
E
Do not tin the wires!
Unbalanced Audio Input
IN1604 DTP and IN1604 HD Scalers • Installation
1 2 3 4 G 1 2 3 4 +V
CONTACT IN TALLY OUT
OVER TP
RS-232
RS-232 IR
Tx Rx G
Rx G
Tx Tx Rx
REMOTE
Analog Video
7