Table of Contents
Advertisement
On-Screen Display (OSD) Menu System
The OSD menu is used primarily when the scaler is initially set up. Configuration and
adjustments can also be performed with SIS commands (see
Control
on page 49). The OSD menu presents configuration options on a local monitor and can be
adjusted with front panel controls.
Menu Navigation Using Front Panel Controls
Menu button — Press the
submenu, or cancel a pending change.
Enter button — Press the
submenu items, or accept pending changes.
Navigation buttons — Press the
submenus or submenu items. Press the
submenus or submenu items. Press the
submenus or submenu items. Also use the navigation buttons to adjust settings according
to specific setting directions.
NOTE: The
Input selection buttons — Press any of the input selection buttons to change the selected
input.
Menu Overview
In the OSD menu, the firmware version is displayed in the top border. The active input
settings and output resolution are displayed in the bottom border. The OSD menu contains
nine submenus with various submenu items of adjustable settings or device information.
Use the Menu, Enter, and Navigation buttons to navigate the OSD menu.
To open the OSD menu:
1.
2.
on page 29) or the Product Configuration Software (see
Menu
Enter
button can be used when the OSD is inactive to quickly change the
Down
output resolution between several rates.
Connect a display device to an HDMI output connector on a DTP receiver connected
to an IN1604 DTP (see
figure
IN1604 HD (see
figure
2,
I
Press the
or
button to open the OSD menu.
Menu
Enter
button to activate or exit the OSD menu, deselect a
button to activate the OSD menu, select submenus or
>
(
) button or the
Up
Down
( ) button to access currently selected
Right
( ) button to exit currently selected
Left
2,
on page 6) or the HDMI output connector on an
G
on page 6).
IN1604 DTP and IN1604 HD Scalers • Operation
SIS Configuration and
Configuration Software
(
) button to navigate
<
15
Advertisement
Chapters
Table of Contents
