Output Connections - Extron electronics IN1604 DT User Manual

Output Connections

IN1604 DTP
100-240V ~ 0.5 A MAX
50-60 Hz
100-240V ~ 0.5 A MAX 100-240V ~ 0.5 A MAX
50-60 Hz 50-60 Hz
Figure 6.
Analog audio output connector — Connect audio output devices to this 5-pole
F
captive screw connector. Wire the connector for line level, balanced or unbalanced,
analog stereo.
Tip
Ring
Sleeves
Tip
Ring
Balanced Audio Output
Figure 7.
TP output connector and TP output switch (IN1604 DTP only) — Connect a DTP
G
receiver or HDBaseT-enabled device to the TP output RJ-45 connector to send all
signals over a single twisted pair cable (see
Communication
Use the recessed switch to the right of the connector to set the signal type to the
type of receiver connected to the TP output connector. Position the switch up to
send HDBaseT signals. Position the switch down to send DTP signals.
ATTENTION:
the TP connector. Failure to comply can damage the endpoint.
ATTENTION :
connecté. Ne pas respecter cela pourrait endommager le point de connexion.
This connection supports the following:
HDCP-compliant digital video and audio
•
RS-232 and IR pass-through signals on the associated 5-pole captive screw
•
connectors
"Over DTP" analog audio (DTP mode only)
•
Remote power to a DTP receiver (DTP mode only)
•
1 CONFIGURABLE 2 HDMI 3 HDMI
4 HDMI
INPUT
1 1 CONFIGURABLE CONFIGURABLE 2 2 HDMI HDMI 3 3 HDMI HDMI
4 4 HDMI HDMI
INPUT INPUT
Output Connectors
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Audio Output Connector Wiring
on page 12 for wiring and cable recommendations).
Position this switch BEFORE connecting the appropriate device to
Positionnez ce interrupteur AVANT d'alimenter le point de connexion
IN1604 DTP and IN1604 HD Scalers • Installation
F
OUTPUT
OUT 1
CONTACT IN
L R
SIG LINK
IN L R
HDBT
1 2
RS-232 IR
DTP
OUT
Tx
AUDIO
G
IN1604 HD
OUT OUT
HDMI
L L R R R R
IN IN
L L R R R R
1 1 2 2
AUDIO AUDIO OUTPUT
I
Unbalanced Audio Output
Twisted Pair Recommendations for DTP
2 3 4 G 1 2 3 4 +V
TALLY OUT
OVER TP
RS-232
Tx Rx G
Rx G Tx Rx
REMOTE
H
1 2 3 4 +V
TALLY OUT
CONTACT IN RS-232
1 2 3 4 G
Tx Rx G
REMOTE
Do not tin the wires!
HDBT
DTP
8