7. If you are instructed to return the DVD drive cable, follow all packaging
Installing the DVD cable
To install the DVD cable, complete the following cable:
instructions, and use any packaging materials for shipping that are supplied to
you.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 127.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables.
3. Align the cable connector with the connector on the rear of the optical drive
cage.
4. Pull the cable connector latch up and hold it there while you slide the cable
connector to the locked position to lock the cable in place.
The following illustration shows the cable routing for the DVD signal cable.
Note: Route the DVD signal cable through the fan cage hole on the left of fan
1.
Cable
connector
latch
Chapter 5. Removing and replacing server components
169