IBM x3250 M3 Problem Determination And Service Manual page 182

10. Insert the ServeRAID adapter into the connector on the riser-card assembly
11. Install the riser-card assembly (see "Installing the riser-card assembly" on page
12. Replace the cover (see "Installing the cover" on page 130).
13. Slide the server in the rack.
14. Reconnect the power cord and any cables that you removed.
15. Turn on the peripheral devices and the server.
164
IBM System x3250 M3 Types 4251, 4252, and 4261: Problem Determination and Service Guide
9. Route the signal cable from the drive backplane through the fan cage hole on
the left of fan 1 as shown in the following illustration.
SAS/SATA signal
cable
Hard disk drive
backplane
configuration cable
Hard disk
drive backplane
until it is firmly seated.
134).
Note: When you restart the server, you are prompted to import the existing
RAID configuration to the new ServeRAID adapter.
Microprocessor
Heatsink
Orientation
DIMMs
DIMMs