IBM x3250 M3 Problem Determination And Service Manual page 193

Connectors
Alignment
slots
1. Connect the cables to the replacement backplane:
v Connect the SAS/SATA controller signal cable to the backplane.
v Connect the power cable to the backplane.
v Connect the configuration cable to the backplane.
2. Slide the backplane into the card guides, making sure that any nearby wires or
cables are not trapped or pinched.
3. Press on the blue touch point firmly until the backplane is fully seated and clicks
into place.
4. Install the cover (see "Installing the cover" on page 130).
5. Replace the hard disk drives.
6. Slide the server into the rack.
7. Connect the cables and power cords.
8. Turn on all attached devices and the server.
Alignment
tabs
Connectors
Chapter 5. Removing and replacing server components
175