Removing An Optional Ibm Serveraid-Mr10Is Vault Sas/Sata Controller; Installing The Optional Ibm Serveraid-Mr10Is Vault Sas/Sata Controller - IBM x3250 M3 Problem Determination And Service Manual

13. Slide the server in the rack.
14. Reconnect the power cord and any cables that you removed.
15. Turn on the peripheral devices and the server.
Removing an optional IBM ServeRAID-MR10is VAULT SAS/SATA
Controller
To remove an IBM ServeRAID-MR10is VAULT SAS/SATA adapter, complete the
following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing the cover" on page 130).
4. Remove the riser-card assembly (see "Removing the riser-card assembly" on
5. Disconnect the signal cable from the ServeRAID-MR10is VAULT SAS/SATA
6. Carefully grasp the end of the ServeRAID adapter and pull it out of the
7. If you are instructed to return the ServeRAID adapter, follow all packaging
Installing the optional IBM ServeRAID-MR10is VAULT SAS/SATA
controller
The optional IBM ServeRAID-MR10is VAULT SAS/SATA controller can be installed
only in its dedicated connector on the riser-card assembly. The ServeRAID-MR10is
VAULT SAS/SATA adapter is supported on hot-swap server models only. The IBM
ServeRAID-MR10is VAULT SAS/SATA adapter with an encryption 1078 DE chip set
enables integrated RAID levels 0, 1, 5, 6, and 10 support capability on hot-swap
hard disk drives. For configuration information, see the documentation on the
ServeRAID CD that comes with the adapter.
Important: To ensure that any of your ServeRAID adapters function properly on
UEFI-based servers, make sure that the adapter firmware level is updated to at
least 11.xx-XXX, and the supporting drivers.
Attention:
updates. If the device is part of a cluster solution, verify that the latest level of code
is supported for the cluster solution before you update the code.
To install the ServeRAID-MR10is VAULT SAS/SATA controller and route the cables,
complete the following steps:
162
IBM System x3250 M3 Types 4251, 4252, and 4261: Problem Determination and Service Guide
Note: When you restart the server, you are prompted to import the existing
RAID configuration to the new ServeRAID adapter.
on page 127.
Note: When you disconnect the power source from the server, you lose the
ability to view the LEDs because the LEDs are not lit when the power source is
removed. Before you disconnect the power source, make a note of which LEDs
are lit, including the LEDs inside the server on the system board.
page 133).
adapter.
connector on the riser-card assembly.
instructions, and use any packaging materials for shipping that are supplied to
you.
Some cluster solutions require specific code levels or coordinated code
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 127.