Removing The Operator Information Panel Assembly; Installing The Operator Information Panel Assembly - IBM x3250 M3 Problem Determination And Service Manual

Removing the operator information panel assembly

To remove the operator information panel assembly, complete the following steps.
1. Read the safety information that begins on page vii and the "Installation
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the server from the rack and remove the cover (see "Removing the
4. Disconnect both cables from the operator information panel board.
5. Remove the screws that secure the operator information panel assembly to the
6. Lift the operator information panel assembly out of the server.
7. If you are instructed to return the operator information panel assembly, follow all

Installing the operator information panel assembly

To install the replacement operator information panel assembly, complete the
following steps:
1. Guide the operator information panel assembly into position on top of the DVD
2. Use the screws that you removed in step 5 of "Removing the operator
3. Connect the light panel cable and front USB cable to the operator information
guidelines" on page 127.
all external cables.
cover" on page 130).
DVD bay housing.
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
bay housing. Make sure that the LEDs and the USB connectors are aligned with
the openings in the bezel and that the holes in the board align with the screw
holes in the top of the bay housing.
information panel assembly" to secure the operator information panel assembly
onto the top of the DVD bay housing.
panel board.
Chapter 5. Removing and replacing server components
171