Installing the bezel
To install the bezel, insert the tab at the right end of the bezel into the front of the
chassis and pivot the bezel until it snaps into place.
Attention:
turn on the server.
Removing the DIMM air baffle
To remove the DIMM air baffle, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the server from the rack and remove the cover (see "Removing the
4. Grasp the air baffle and lift it up out of the server.
5. Remove it from the server and set it aside.
132
IBM System x3250 M3 Types 4251, 4252, and 4261: Problem Determination and Service Guide
Bezel
For proper cooling and airflow, replace the server cover before you
on page 127.
external cables.
cover" on page 130).
Release
latch
Air baffle