Table of Contents
Advertisement
Notes:
1. To select a new value, press the Enter key when the value is displayed in the
2. Values set in PostScript print jobs (either by the print application or the printer
3. If you are unfamiliar with using the operator panel to work with menus, please
PS Menu Item
PAGEPROT
AUTO*
ON
COPIES
nnn
PRINT ERRS
OFF*
ON
EDGE-EDGE
ON*
OFF
IPDS Menu
The following table describes the settings you can change from the IPDS Menu. An
asterisk (*) next to a value in the table indicates the factory default. The IPDS Menu
appears only if you have the IPDS SIMM installed.
Notes:
1. To select a new value, press the Enter key when the value is displayed in the
2. Values specified in IPDS print jobs override IPDS Menu values set at the printer.
3. If you are unfamiliar with using the operator panel to work with menus, please
message display area. An asterisk (*) appears next to the value in the message
display area, indicating that it is now active.
driver) override PS Menu values you set at the printer.
read "Using the Operator Panel Keys" on page 16 and "Navigating Menus" on
page 17 before continuing.
Value
Sets page protection:
v AUTO—the printer protects the minimum amount of memory
necessary.
v ON—the printer reserves enough memory to process an entire
page without compression before it prints the page. This can help
in the rare case where the printer compression scheme causes a
loss of quality in complex graphics. This setting is available only
when the printer has enough memory. See "Memory
Requirements" on page 4 for more information.
Specifies how many copies of each job to print. nnn can be from 1
to 999. 1 is the default.
Specifies how the printer handles PostScript errors:
v OFF—the printer cancels the job, but does not print an error
page.
v ON—the printer prints an error page and cancels the job.
Turns edge-to-edge printing on or off.
v ON—The printer allows printing up to the physical page size.
v OFF—the printer maintains a border of 4 mm on all four paper
sides.
Notes:
1. IBM recommends leaving EDGE-EDGE set to ON when you use
IBM printer drivers. If you use non-IBM printer drivers, you may
need to set EDGE-EDGE to off to prevent toner contamination in
the printer.
2. The IBM printer driver cannot override the OFF setting. If you
set EDGE-EDGE to OFF, you cannot print edge-to-edge.
message display area. An asterisk (*) appears next to the value in the message
display area, indicating that it is now active.
read "Using the Operator Panel Keys" on page 16 and "Navigating Menus" on
page 17 before continuing.
Description
Chapter 6. Operator Panel Menus
79
Advertisement
Table of Contents
