Network Interface Cards - IBM InfoPrint 20 User Manual

Hide thumbs Also See for InfoPrint 20:
Table of Contents

Advertisement

3. Tighten the thumbscrews (5) at the top and bottom of the side cover mounting
4. Connect the power cord to the back of the printer.
5. Connect the other end of the power cord to a grounded AC outlet.
6. Switch the printer power on.
7. After the printer warms up, the READY message displays on the operator panel.
8. To confirm that you have correctly installed a memory SIMM, hard drive, data
9. Make sure you update your printer driver to indicate the new DRAM SIMM,

Network Interface Cards

The InfoPrint 20 attaches to networks and other system configurations through
these optional cards:
v IBM Network Card for Ethernet (10BaseT/10Base2)
v IBM Network Card for Token Ring
v IBM Twinax SCS Interface Card
v IBM Coax SCS Interface Card
bracket.
stream SIMM, or any combination, print a configuration page. The configuration
page lists the features if they have been correctly installed. See "Printing the
Printer Configuration Page" on page 18.
Note: If the options do not appear for the SIMM or hard drive, remove the side
cover, make sure that the SIMM or hard drive is correctly seated, and
reinstall the side cover.
Flash Memory SIMM, or hard drive is installed.
Chapter 8. Installing Printer Options
117

Advertisement

Table of Contents
loading

Table of Contents