Table of Contents
Advertisement
Paper Menu Item
SOURCE
TRAY1*
TRAY2
TRAY3
AUXTRAY
DUPLEX
OFF*
ON
BINDING
LONG*
SHORT
Value
Selects the default paper tray to use. Only installed trays appear in
the list.
v TRAY1 is the standard 500-sheet input tray. It can be A4/Letter
size or A3/Ledger (11 x 17) size.
v TRAY2 and TRAY3 are optional input trays; you can install one or
two additional 500-sheet trays, one additional 500-sheet tray and
the 2000-Sheet Input Drawer, or just the 2000-Sheet Input
Drawer. If you do not install them, they will not be in the list. If
you install one additional tray, it is TRAY2. If you install two
additional trays, the middle tray is TRAY2 and the lower tray is
TRAY3. The 2000-Sheet Input Drawer must be the lowest tray.
v AUXTRAY is the flip-down tray in the front of the printer.
Notes:
1. If the 2000-Sheet Input Drawer is installed, it is the default tray.
2. If the envelope tray is installed, it is referred to as TRAY1,
TRAY2, or TRAY3, depending on which paper tray it replaces.
Specifies whether to print on one side or both if the duplex unit is
installed. See "Making Duplex or Simplex Printing the Printer
Default" on page 49.
Specifies how to print pages in duplex mode.
v LONG—prints as if the paper is to be bound along the long edge
of the paper (on the left for portrait documents, on the top for
landscape documents).
v SHORT—prints as if the paper is to be bound along the short
edge of the paper (on the top for portrait documents, on the left
for landscape documents).
Description
Chapter 6. Operator Panel Menus
69
Advertisement
Table of Contents
