Table of Contents
Advertisement
The 500-Sheet Paper Tray
Each 500-sheet paper tray option consists of:
v A paper tray support unit that attaches to the printer
v A paper tray that holds the paper and is inserted into the support unit.
This section describes how to install one or two paper tray support units with
500-sheet paper trays and how to remove and uncouple the two support units.
Because this option, when installed, significantly increases the weight of the printer,
consider installing the trays after other options are installed.
Installing 500–Sheet Paper Trays
Preparing the Printer
Use the following procedure to prepare the printer before installing paper trays:
1. Switch the printer power off.
2. Unplug the printer from the wall outlet.
3. Remove the power cord from the back of the printer.
4. Unpack the paper tray support unit or units. Place each paper tray support unit
5. Remove the tape and packing materials from the paper tray support unit.
6. Save the packing materials for future use.
7. If you have two trays, go to "Stacking Two 500-Sheet Paper Trays". Otherwise,
Stacking Two 500-Sheet Paper Trays
Use the following procedure to stack and fasten two 500-sheet paper tray support
units:
1. Lift one of the paper tray support units by the recessed grips and set it on top of
Important
InfoPrint 20 supports two paper tray sizes: A4/Letter and A3/Ledger (11 x 17).
Use the procedures in this section for either size.
on a flat stable surface.
go to "Placing the Printer on the Paper Tray Support Unit" on page 126.
the other support unit. The front of each paper tray must face the same
Chapter 8. Installing Printer Options
125
Advertisement
Table of Contents
