Table of Contents
Advertisement
|
|
|
|
|
|
Action: If the AUTOCONTINU item in the Config Menu is set to ON,
printing resumes in ten seconds. Make sure paper is correctly loaded in the
tray and the end guides in the tray are properly set. For the auxiliary tray,
verify the AUXSIZE setting on the Paper Menu (see "Defining the Auxiliary
Tray Paper Size" on page 48). You may also need to open and close the
top cover to clear the condition.
29 OUTPUT FULL
Meaning: The output bin is full.
Action: Remove the output from the bin.
30 MEMORY OVERFLOW
Meaning: Memory overflow. The printer has received more data than it can
fit into its memory. This can happen when the printer receives too many soft
fonts, macros, or complex graphics.
Action: If the AUTOCONTINU item in the Config Menu is set to ON,
printing resumes in ten seconds. Otherwise, press the Continue key. Check
the current page for errors. See "Memory Requirements" on page 4 for
information on how much memory various options require.
31 MEMORY ALLOC ERROR
Meaning: The printer cannot allocate the memory required to print a job.
Action: If the AUTOCONTINU item in the Config Menu is set to ON,
printing resumes in ten seconds. Otherwise, press the Continue key. Check
the current page for errors.
32 PRINT OVERRUN
Meaning: A page is too complex to print at the current resolution.
Action: Do one of the following:
v If QUALITY is set to 1200, change it to something else and resubmit the
job. Use your printer driver or the Config Menu. The driver setting
overrides the menu setting. See "Configuration (Config) Menu" on
page 72.
v If you are feeding paper long-edge first, change it to short-edge first.
v Add more memory. See "Memory Requirements" on page 4 for
information on how much memory various options require.
40 MEMORY OPTION ERROR
Meaning: A SIMM module is not properly seated in its slot or is in some
other way defective.
Action: Turn off the printer. Pull out the controller card. Reseat the SIMM
module. If the message recurs after you restart the printer, call for service.
41 NETWORK OPTION ERROR
Meaning: The printer detected a network interface card in the top slot, but
the card is not communicating.
Action: Make sure the network interface card is properly installed and
restart the printer. See "Installing a Network Interface Card" on page 118. If
the message recurs, call for service. Remove the network interface card
from the printer if you want to print a printer configuration page or if you
want to print from the parallel port.
42 NETWORK OPTION ERROR
Meaning: The printer detected a network interface card in the bottom slot,
but the card is not communicating.
Appendix C. Printer Messages
163
Advertisement
Table of Contents
