Table of Contents
Advertisement
7. To restore the printer to READY status, press the Online key.
Other Operator Panel Tasks
The rest of this chapter contains examples of how to perform some other common
operator panel tasks. In addition, "Common Paper Handling Tasks" on page 47
contains examples of how you can use the operator panel to change Paper Menu
settings, such as default input trays and default paper sizes. "Chapter 9. Configuring
Printer Network Addresses" on page 141 describes how to set TCP/IP network
values (IP address, gateway address, subnet mask, locally administered MAC
address) from the operator panel.
Making Duplex or Simplex Printing the Printer Default
Situation: You have the duplex unit installed and you want to make duplex printing
or simplex printing the printer default.
Note: Values set in print jobs (either by the print application or by the printer driver)
Action:
1. Press the Online key until you see OFFLINE in the display.
2. Press the Menu key until you see PAPER MENU in the display.
3. Press the Item key until you see DUPLEX=ON* or DUPLEX=OFF in the display.
4. Press the Value key until you see the new value you want.
5. Press the Enter key to select the new setting. An asterisk appears next to the
6. To restore the printer to READY status, press the Online key.
Notes:
1. The BINDING item on the Paper Menu lets you specify how you want duplex
20
InfoPrint 20: User's Guide -- Web Version
– Toner CTR—The number of pages printed since the toner counter was
reset. You should reset the toner count whenever you replace the toner
cartridge. See "Machine Information Menu" on page 99 for more
information.
– Fuser CTR—The number of pages printed with the fuser since the fuser
counter was reset. You should reset the fuser counter whenever you
replace the usage kit. See "Machine Information Menu" on page 99 for
more information.
– Code Levels—Code levels of the printer controller and other programs.
- CTL—The code level of the printer controller.
- PCL—The code level of the printer PCL code.
- PS—The code level of the printer PostScript code.
Note: In addition to the code levels listed here, the configuration page will
list code levels for other installed options, such as network interface
cards.
override values you set at the printer. If a print job specifies simplex printing
and the printer default is duplex, the printer honors the print job setting and
prints on one side only.
value, showing that it is active.
jobs to print. If BINDING is set to LONG (the default value) the job prints as if
the paper is to be bound along the long edge of the paper. (On the left for
portrait documents, along the top for landscape documents.) If you set BINDING
Advertisement
Table of Contents
