Table of Contents
Advertisement
3. Remove the power cord from the back of the printer.
4. Loosen the thumbscrews located on the side cover at the back of the printer.
5. To install a SIMM, see "Installing a SIMM". To install a hard drive, see "Installing
Installing a SIMM
Use the following procedure to install a SIMM:
1. Ensure that printer is powered off and unplugged from the wall outlet.
2. The side cover must be removed before installing a SIMM. Follow the procedure
3. Locate the correct socket group for the type of SIMM you are installing. There
114
InfoPrint 20: User's Guide -- Web Version
Slide the side cover toward the back of the printer to release the tabs and
hooks, and remove the side cover.
a Hard Drive" on page 115.
Attention
Follow the instructions for handling static-sensitive devices described on page
113.
"Removing the Side Cover" on page 113.
are two socket groups: one contains three sockets, the other contains four
sockets. The DRAM SIMMs (memory) must be installed in one of the sockets in
the socket group of three. The IPDS SIMM and the flash memory SIMMs must
be installed in one of the sockets in the socket group of four.
SIMMs should be loaded from the left to the right but the position of the SIMM
within the group of sockets does not matter.
Advertisement
Table of Contents
