System To Stay On-Line Or Hang-Up After Touch-Tone Number Pressed; Automatic Hang-Up Function; Section 3.2 Phone Number And Directory Code Programming; Programming The Directory Code Length - DKS 1802 Installation & Owner's Manual

3.1.13 System to Stay On-Line or Hang Up after Touch Tone Number Pressed
This programming sequence provides a method for the telephone entry system to remain on-line after a resident has pressed
the touch tone number to open the door or gate. Each relay can be set independently to either remain on line or hang up.
Factory setting = 1 (hang up after touch tone number pressed) for both relays.
ABC ABC TUV TUV
1. Press and enter your four-digit MASTER CODE
2 2 8 8
SP SP
2. Press (beep) for relay 1, OR
1 1
OPER OPER
3. Press (beep) to keep the system on-line, OR
0 0
4. Repeat steps 2 and 3 to program other relay.
OPER OPER
5. Press together to end this programming sequence (beeeeeep).
0 0

3.1.14 Automatic Hang-up Function

This programming sequence determines when the phone system will automatically hang itself up after a predetermined time of
inactivity. You can program the system to not hang-up (0), to hang-up after 5 sec of dial-tone (1), to hang-up after 15 sec of
silence (2) or to hang-up after either 5 sec of dial-tone or 15 sec of silence (3).
Factory setting = 1 (hang-up after 5 sec of dial-tone).
GHI GHI OPER OPER
1. Press and enter your four-digit MASTER CODE
4 4 0 0
2. Enter the single-digit hang-up code desired (0, 1, 2 or 3), then press
OPER OPER
3. Press together to end this programming sequence (beeeeeep).
0 0
Hang-up Code
3.2 Phone Number and Directory Code Programming

3.2.1 Programming the Directory Code Length

This programming sequence sets the directory code length to 1 - 2 - 3 or 4 digits. If 11 or more resident names or telephone
numbers are going to be programmed into the system, the directory code must be at least two-digits. If 101 or more resident
names or telephone numbers are going to be programmed, the directory code must be at least three-digits.
Factory setting is three (3) digits.
CAUTION: After programming this sequence, it is NOT recommended changing the directory code length.
Reprogramming this sequence in the future will delete ALL phone numbers and directory codes that have
been previously programmed into the system.
ABC ABC OPER OPER
1. Press and enter your four-digit MASTER CODE
2 2 0 0
2. Enter the directory code digit length (1, 2, 3 or 4), then press
OPER OPER
3. Press (beep) to cancel this function, OR
0 0
The programming sequence will automatically end itself after pressing
24
ABC ABC
(beep) for relay 2.
2 2
0
1
2
3
? ? ? ? ? ? ? ?
SP SP
(beep) to make it hang up.
1 1
? ? ? ? ? ? ? ?
(beep).
No hang-up.
Hang-up after 5 sec. of dial-tone (Factory setting).
Hang-up after 15 sec. of silence.
Hang-up after 5 sec. of dial-tone OR 15 sec. of silence.
? ? ? ? ? ? ? ?
(beep).
SP SP
(beeeeeep) to confirm the change.
1 1
SP SP
1 1
(beep).
(beep).
Function
(beep).
. This CANNOT be UNDONE!
1802-065-D-10-14