Programming Phone Numbers With Area Code Reference Numbers; Deleting Individual Phone Number; Deleting All Phone Numbers; Caution 26 3.2.6 - DKS 1802 Installation & Owner's Manual

3.2.4 Programming Phone Numbers WITH Area Code Reference Numbers

Program phone numbers that are referenced to an area code (long distance and 10-digit dialing calls). Make sure that the area
code(s) have already been programmed with area code reference numbers in previous section 3.2.3.
Note: If long distance or 10-digit dialing is NOT required, program the seven digit telephone
numbers as described in section 3.2.2.
GHI GHI SP SP
1. Press and enter your four-digit MASTER CODE
4 4 1 1
2. Choose and enter a directory code (1, 2, 3 or 4 digits, depending on what was programmed in 3.2.1), then press
3. Enter the two-digit area code reference number (01 through 15), then press
See tables on previous page and log tables in back of this manual for area code reference numbers that have been programmed in.
4. Enter a seven-digit phone number for the chosen directory code, then press
If the number that you are entering in this step is LESS than seven-digits, enter # in the empty spaces. For example, if the
system is connected to a PBX that requires four-digit extension numbers and you want to enter extension 2217, you would
ABC ABC
enter this number as:
2 2
5. Repeat steps 2, 3 and 4 to enter additional long distance phone numbers.
OPER OPER
6. Press together to end this programming sequence (beeeeeep).
0 0

3.2.5 Deleting Individual Phone Number

This programming sequence is used to delete a SINGLE phone number under a known directory code.
OPER OPER SP SP
1. Press and enter your four-digit MASTER CODE
0 0 1 1
2. Enter the directory code (1, 2, 3 or 4 digits, depending on what was programmed in 3.2.1), then press
3. Enter
4. Repeat steps 2 and 3 to delete additional phone numbers.
OPER OPER
5. Press together to end this programming sequence (beeeeeep).
0 0

3.2.6 Deleting ALL Phone Numbers

This programming step deletes ALL phone numbers previously programmed into the system.
CAUTION: This programming step CANNOT be UNDONE!
ABC ABC ABC ABC
1. Press and enter your four-digit MASTER CODE
2 2 2 2
WXYZ WXYZ WXYZ WXYZ WXYZ WXYZ
2. Enter
9 9 9 9 9 9
This programming sequence will automatically end itself by a long (beeeeeep).
26
ABC ABC SP SP PQRS PQRS
2 2 1 1 7 7
, then press
WXYZ WXYZ
, then press (beep). This CANNOT be UNDONE!
9 9
? ? ? ? ? ? ? ?
then press (beep).
? ? ? ? ? ? ? ?
(beep). This CANNOT be UNDONE!
? ? ? ? ? ? ? ?
(beep).
(beep).
(beep).
(beep).
(beep).
(beep).
(beep).
1802-065-D-10-14