Table of Contents
Advertisement
3.1.7 Number of Rings / Ring Type
This programming sequence sets up the 1816 system for: 1) the number of rings allowed before the
system automatically hangs up, 2) a single or double ring. A two digit number will be entered to set up
these operating parameters, with each number of the code corresponding to the respective functions
listed.
Factory Default = 31
1. Take the doorman telephone off hook.
2. Press *04 and enter the four-digit MASTER
CODE _ _ _ _ (beep).
3. Enter the two-digit ring/ring type code _ _
then press * (beep).
4. Hang up the doorman telephone to end the
programming session.
3.1.8 Tone Open Number Programming
The tone open number is the number that is pressed on the resident's telephone to activate the relay
on the 1885 control board. The resident can only activate the relay momentarily, but other relay
functions are available from the doorman/concierge phone and by remote relay activation. The four
relay functions are: 1) momentary activation, 2) continuous activation (relay latch), 3) deactivation
(unlatch), 4) activate for one hour, then automatically deactivate. If a function is not going to be used,
enter a # sign in place of the respective digit. Do not use the number "3" as a tone open number since
this number is reserved to activate the call waiting feature. Do not duplicate tone open numbers.
NOTE: When used with a DoorKing Lobby Panel, the 1816 and lobby panel Tone Open Number
programming must match. Refer to the lobby panel programming instructions to program the
lobby panel Tone Open Number programming.
Factory Default = 9 # # #
1. Take the doorman telephone off hook.
2. Press *05 and enter the four-digit MASTER
CODE _ _ _ _ (beep).
3. Enter the four-digit tone code _ _ _ _ then
press * (beep).
4. Hang up the doorman telephone to end the
programming session.
3.1.9 Relay Strike Time
The relay strike time is the amount of time that the relay on the 1885 control board will be energized
when activated by a tone open number, entry code number, or key switch (postal lock) input. Typical
strike time is 5 seconds for an electric strike or magnetic lock release.
Factory Default = 01
1. Take the doorman telephone off hook.
2. Press *03 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Enter the two-digit strike time code (00 – 99) _ _ then press * (beep). Note: 00 = ¼ sec.
4. Hang up the doorman telephone to end the programming session.
Page 28
Code
Number
Digit
The number of rings before the
st
1
2 - 9
1816 automatically hangs up.
Enter 0 for a standard single ring,
nd
2
0 or 1
or enter 1 for a double ring.
Code
Number
Digit
Activate the relay for the
st
1
2, 4-9
programmed strike time.
Activates the relay continuously
nd
2
(relay latch).
Deactivates the relay (relay
rd
3
unlatch).
Activates relay for 1-hour, then
th
4
automatically deactivates.
Description
Description
1816-065-L-11-14
Advertisement
Table of Contents
