System Parameters - Programming Via Keypad / Touch-Tone Telephone - DKS 1812 Owner's Manual

2.4 System Parameters Programming
IMPORTANT! We strongly suggest that you read these programming instructions in their
entirety before beginning any manual programming of the 1812 Access Plus system.
The programming table on the next page provides a quick reference to the
Programming from the Keypad
Follow the programming instructions as described in each section of this manual. The system will
prompt you with short tones (beep) when programming steps have been followed correctly and with a
long tone (beeeeeep) when the programming step is ended.
Programming with a Touch-Tone Telephone
Follow these steps when programming the 1812 Access Plus from the resident's touch-tone
telephone. NOTE: The system attention number is factory set to 7. This can be changed to any
number, see section 2.4.3.
1. Press * and then the system attention number. [ * 7 (beep)]
2. Follow the programming instructions as described in each section of this manual. The system
will prompt you with short (beep) tones when programming steps have been followed
correctly.
3. When complete, hang up.
Follow these steps when programming the 1812 from an off-site touch-tone telephone. NOTE: The
1812 must be programmed to answer incoming calls, section 2.4.9.
1. Call the resident telephone number. The 1812 will answer with a short beep after the
programmed number of rings.
2. Follow the programming instructions as described in each section of this manual. The system
will prompt you with short (beep) tones when programming steps have been followed
correctly.
3. When complete, hang up.
1812-162-B-6-09 Page 31