Touch-Tone / Rotary-Dial; Touch-Tone / Rotary-Dial; Rotary-Dial 9 Relay(S) Activation; Rotary Dial-9 Relay(S) Activation - DKS 1834 PC Programmable Installation & Owner's Manual

3.3.5 Touch-Tone / Rotary-Dial

This programming sequence will set the telephone entry system to dial out in either a touch-tone or rotary format. Generally,
this will be set for touch-tone.
Factory setting = touch-tone.
OPER OPER PQRS PQRS
1. Press and enter your four-digit MASTER CODE
0 0 7 7
OPER OPER
2. Press (beep) for touch-tone, OR
0 0
OPER OPER
3. Press together to end this programming sequence (beeeeeep).
0 0
3.3.6 Rotary-Dial 9 Relay
This programming sequence sets which relay(s) will activate when the system receives a rotary-dial 9 open command from a
residents rotary telephone. The system can be programmed so that only one relay will activate, or both relays will activate. TIP:
The relay that you designate as the primary relay should be programmed to activate from a rotary 9 command.
Factory setting = 010 (only relay 1 activates)
JKL JKL SP SP
1. Press and enter your four-digit MASTER CODE
5 5 1 1
2. Enter the three-digit (1's or 0's only) rotary 9 code, then press
Three-digit positions: 1st digit position - Always Set to "0", 2nd digit position - Relay 1, 3rd digit position - Relay 2.
To activate a relay - enter a 1 in the second or third digit position.
To NOT activate a relay - enter a 0 in the second or third digit position.
Example: entering 010 will cause only relay 1 to activate. Entering 011 will cause both relays to activate.
OPER OPER
3. Press together to end this programming sequence (beeeeeep).
0 0
30
? ?
SP SP
(beep) for Rotary
1 1
s Activation
( )
? ?
? ? ? ? ? ?
(beep).
? ? ? ? ? ?
(beep).
(beep).
1834-065-B-10-14