System Administrator - DKS 1802 Installation & Owner's Manual

4.2 System Administrator

The administrator can perform the following operations from a remote location (off-site)
using a touch-tone telephone. You must know the phone number of the system and the
system's four-digit MASTER CODE.
4.2.1 Remote Programming (Touch-Tone Phone)
1. Call the telephone number that the entry system is installed on. The system will answer with a short tone (beep heard).
Note: the number of rings before the system answers is dependent on the programming in 3.1.9.
2. After the system answers, follow the desired programming steps in Section 3.
3. When complete, hang up. You cannot use 0 # together to end the programming step from a touch-tone telephone.
4.2.2 Remote Relay Activation
1. Call the telephone number that the entry system is installed on. The system will answer with a short tone (beep heard).
Note: the number of rings before the system answers is dependent on the programming in 3.1.9.
2. Press 16 and enter the four-digit MASTER CODE (beep heard).
*
3. Press the desired single-digit tone open number (beep heard).
Note: Refer to 3.1.5 to determine which tone open features have been programmed, i.e. momentary open, hold open,
release, hold open one hour and then release.
4. Hang up.
4.2.3 Remote Relay Check
The telephone entry system can be called and a check can be made to determine if any of the relays in the system are in a
"Hold Open" mode. This check can be useful if your gate (or door) is held open and you suspect that the telephone entry
system relay may be the cause.
1. Call the telephone number that the entry system is installed on. The system will answer with a short tone (beep heard).
Note: the number of rings before the system answers is dependent on the programming in 3.1.9.
2. Press 16 and enter the four-digit MASTER CODE (beep heard).
*
3. The system will emit a series of short tones if the relay is in a continuous activation mode.
Relay 1 activated: beep - pause - beep - pause . . .
Relay 2 activated: beep beep - pause - beep beep - pause . . .
Relay 1 & 2 activated: beep beep beep - pause - beep beep beep - pause . . .
4. Press the programmed single-digit tone number to deactivate the relay (beep heard). The system will automatically hang up.
Note: the single-digit tone number is dependent on the programming in 3.1.6 (factory defaults: Relay 1 - 7, Relay 2 - 3).
1802-065-D-10-14
2
1 8 0
39