Number Of Rings Before Telephone Entry System Will Answer; Pbx Line Access Code Programming; Star Key ( * ) Function - DKS 1802 Installation & Owner's Manual

3.1.9 Number of Rings Before Telephone Entry System will Answer

This programming sequence sets the number of rings to allow before the telephone entry system answers a call placed to it.
This programming sequence does not affect the number of times that a resident's telephone will ring when a call is placed from
the entry system to the resident.
Factory setting = 02 (two rings).
SP SP TUV TUV
1. Press
1 1 8 8
2. Enter a two-digit number of rings, then press
OPER OPER
3. Press together to end this programming sequence (beeeeeep).
0 0

3.1.10 PBX Line Access Code Programming

If the telephone entry system is connected to a PBX telephone system rather than a dedicated C.O. line, you may need to set
the unit to dial a line access code prior to dialing the resident phone number. Typically, the line access code is "9", but check
with the PBX system administrator to be sure.
ABC ABC SP SP
1. Press
2 2 1 1
2. Enter the single-digit line access code number, then press
OPER OPER
3. Press together to end this programming sequence (beeeeeep).
0 0
Note: To change a line access number, enter the correct number in step 2. To delete a line access number, enter
3.1.11 Star Key
This programming sequence sets the function of the
hang-up the entry system when pressed during conversation, or it can be programmed to touch-tone out during conversation.
Factory setting = 0 (hang-up).
ABC ABC PQRS PQRS
1. Press
2 2 7 7
OPER OPER
2. Press (beep) for hang-up, OR
0 0
OPER OPER
3. Press together to end this programming sequence (beeeeeep).
0 0
3.1.12 Keypad Function (DTMF Tone Programming)
This programming sequence sets the function of the 0 through 9 and the
keys can be set to hang-up the entry system when they are pressed during conversation, or they can be programmed to DTMF
tone out during conversation. The later may be desirable if the entry system is used with an auto-attendant type telephone
system where the caller is prompted to enter numbers from a touch-tone telephone.
TIP: If DTMF tones are required, program the # or
Factory setting = 0 for all numbers (hang-up).
ABC ABC MNO MNO
1. Press
2 2 6 6
2. Enter the single-digit desired key number, then press
OPER OPER
3. Press (beep) for hang-up, OR
0 0
4. Repeat steps 2 and 3 to program other keys.
OPER OPER
3. Press together to end this programming sequence (beeeeeep).
0 0
1802-065-D-10-14
and enter your four-digit MASTER CODE
and enter your four-digit MASTER CODE
Function
and enter your four-digit MASTER CODE
SP SP
1 1
and enter your four-digit MASTER CODE
SP SP
1 1
? ? ? ? ? ?
(beep).
? ? ? ? ? ?
(beep).
key on the keypad during conversation. This key can be set to
? ? ? ? ? ?
(beep) for touch-tone.
, # keys on the keypad during conversation. The
*
key to hang-up the system.
*
? ? ? ? ? ?
(beep).
(beep) for touch-tone.
? ?
(beep).
? ?
(beep).
? ?
(beep).
? ?
(beep).
in step 2.
23