Entry Code Programming; Section 3.4 Entry Code Programming; Programming Four-Digit Entry Code; Delete Individual Four-Digit Entry Code - DKS 1802 Installation & Owner's Manual

3.4 Entry Code Programming

3.4.1 Programming Four-Digit Entry Code

This programming sequence programs four-digit entry codes into the system memory. The number of four-digit entry codes
that can be programmed is the same as the telephone number memory capacity, plus 12. We suggest that all entry codes that
are programmed into the system be listed with the names of residents that they have been assigned to (see log tables in back of
this manual).
Note: Temporary four-digit entry codes can be programmed into system that will only be active for 24 hours. See section 3.5.5
for more information about "Flash entry Codes" if this feature is desired (Time clock must be programed, section 3.5.1).
OPER OPER ABC ABC
1. Press
0 0 2 2
2. Enter the four-digit entry code, then press
3. Repeat step 2 to enter additional entry codes.
OPER OPER
4. Press together to end this programming sequence (beeeeeep).
0 0

3.4.2 Delete Individual Four-Digit Entry Code

SP SP GHI GHI
1. Press
1 1 4 4
2. Enter the four-digit entry code to be deleted, then press
3. Repeat step 2 to delete additional entry codes.
OPER OPER
4. Press together to end this programming sequence (beeeeeep).
0 0

3.4.3 Delete ALL Four-Digit Entry Codes

This programming step deletes ALL four-digit entry codes that have been programmed into the system.

CAUTION:

This programming CANNOT be UNDONE!
OPER OPER OPER OPER
1. Press
0 0 0 0
WXYZ WXYZ WXYZ WXYZ WXYZ WXYZ
2. Press
9 9 9 9 9 9
This programming sequence will automatically end itself by a long (beeeeeep).

3.4.4 Four-Digit Entry Code Divide Number to Activate Relays

The four-digit entry codes can be made to activate either relay 1 or relay 2 by programming a four- digit divide number.
Four-digit entry codes equal to or less than the divide number will activate relay 1. Four-digit entry codes greater than the
divide number will activate relay 2.
TIP: you can make ALL four-digit entry codes (except 0000) activate Relay 2 by programming divide number 0000, or make
ALL four-digit entry codes activate Relay 1 by programming divide number 9999.
Factory default divide number is 9999 - Activates Relay 1.
SP SP ABC ABC
1. Press
1 1 2 2
2. Enter the four-digit divide number, then press
OPER OPER
3. Press together to end this programming sequence (beeeeeep).
0 0
1802-065-D-10-14
and enter your four-digit MASTER CODE
and enter your four-digit MASTER CODE
and enter your four-digit MASTER CODE
WXYZ WXYZ
then press (beep).
9 9
and enter your four-digit MASTER CODE
? ? ? ? ? ?
(beep).
? ? ? ? ? ?
(beep).
? ? ? ? ? ?
? ? ? ? ? ?
(beep).
? ?
(beep).
? ?
(beep).
? ?
(beep).
? ?
(beep).
33