Table of Contents
Advertisement
TRENDnet User's Guide
Shared secret: A secret key used between system and RADIUS server. Supports 8
o
to 64 characters.
Accounting RADIUS Server: Enable to set Account RADIUS server.
o
•
WEP 802.1X: When WEP 802.1x Authentication is enabled, please refer to the
following Dynamic WEP and RADIUS settings to complete configuration.
Radius Server Settings:
•
IP Address: Enter the IP address of the Authentication RADIUS server.
o
Port: By default, it's 1812. The port number used to communicate with RADIUS
o
server.
Shared secret: A secret key used between system and RADIUS server. Supports 8
o
to 64 characters.
Accounting RADIUS Server: Enable to set Account RADIUS server.
o
Key Index : key index is used to designate the WEP key during data transmission.
o
4 different WEP keys can be entered at the same time, but only one is chosen.
WEP Key # : Enter HEX or ASCII format WEP key value; the system supports up to
o
4 sets of WEP keys.
WPA-PSK (or WPA2-PSK) : WPA (or WPA2) Algorithms, allows the system
o
accessing the network by using the WPA-PSK protected access.
Wireless AP MAC Filter Setup
The administrator can allow or reject clients to access Repeater AP.
© Copyright 2014TRENDnet. All Rights Reserved.
MAC Filter Setup: By default, it's "Disable". Options are Disable, Only Deny List
•
MAC or Only Allow List MAC.
•
Two ways to set MAC filter rules:
o Only Allow List MAC: The wireless clients in the "Enable" list will be allowed to
access the Access Point; All others or clients in the "Disable" list will be denied.
o Only Deny List MAC: The wireless clients in the "Enable" list will be denied to
access the Access Point; All others or clients in the "Disable" list will be allowed.
MAC: Enter MAC address (e.g. aa:bb:cc:00:00:0a) and click "Add" button, then the
•
MAC address should display in the "Enable" List.
There are a maximum of 20 clients allowed in this "Enable" List. The MAC addresses of
the wireless clients can be added and removed to the list using the Add and Remove
buttons. Click Apply button to activate your changes
Access Control
DMZ
DMZ is commonly work with the NAT functionality as an alternative of Virtual
Server(Port Forwarding) while wanting all ports of DMZ host visible to Internet users.
Virtual Server rules have precedence over the DMZ rule. In order to use a range of ports
available to access to different internal hosts Virtual Server rules are needed.
DMZ: By default, it's "Disable". Check Enable radial button to enable DMZ.
•
IP Address: Enter IP address of DMZ host and only one DMZ host is supported.
•
TEW-738APBO
62
Advertisement
Table of Contents
