Table of Contents
Advertisement
TRENDnet User's Guide
Product Benefit
The 10 dBi Outdoor PoE Access Point is the point of connection to Wireless Outdoor
Network for service provider deploying last mile services to business or residential
broadband subscribers.. Network administrators can create multiple subscriber service
tier using per-subscriber rate limiting features, and manage centrally.
Installation Considerations
There are a number of factors that can impact the range of wireless devices.
1. Adjust your wireless devices so that the signal is traveling in a straight path, rather
than at an angle. The more material the signal has to pass through the more signal
you will lose.
2. Keep the number of obstructions to a minimum. Each obstruction can reduce the
range of a wireless device. Position the wireless devices in a manner that will
minimize the amount of obstructions between them.
3. Building materials can have a large impact on your wireless signal. In an indoor
environment, try to position the wireless devices so that the signal passes through
less dense material such as dry wall. Dense materials like metal, solid wood, glass
or even furniture may block or degrade the signal.
4. Antenna orientation can also have a large impact on your wireless signal. Use the
wireless adapter's site survey tool to determine the best antenna orientation for
your wireless devices.
5. Interference from devices that produce RF (radio frequency) noise can also impact
your signal. Position your wireless devices away from anything that generates RF
noise, such as microwaves, radios and baby monitors.
If you are still experiencing low or no signal consider repositioning the wireless devices
or installing additional access points. The use of higher gain antennas may also provide
the necessary coverage depending on the environment.
© Copyright 2014TRENDnet. All Rights Reserved.
Installation
1. Unscrew the black cap covering the PoE port of the TEW-738APBO
2. Install the waterproof kit and insert one end of an Ethernet cable through the kit.
3. Connect the Ethernet cable to the PoE port of the TEW-738APBO
4. Tighten and secure the seal nut of the waterproof kit.
5. Connect the other end of the Ethernet cable to the P+DATA Out port on the PoE
injector.
TEW-738APBO
7
Advertisement
Table of Contents
