Table of Contents
Advertisement
TRENDnet User's Guide
ro community: Set a community string to authorize read-only access.
o
rw community: Set a community string to authorize read/write access.
o
SNMP v3 Enable: Check to enable SNMP v3. SNMPv3 supports the highest level
•
SNMP security.
SNMP ro user: Set a community string to authorize read-only access.
o
SNMP ro password: Set a password to authorize read-only access.
o
SNMP rw user: Set a community string to authorize read/write access.
o
SNMP rw password: Set a password to authorize read/write access.
o
SNMP Trap: Events such as cold start, interface up & down, and association &
•
disassociation will report to an assigned server.
Community: Set a community string required by the remote host computer that
o
© Copyright 2014TRENDnet. All Rights Reserved.
will receive trap messages or notices send by the system.
IP: Enter the IP addresses of the remote hosts to receive trap messages.
o
Click Save button to save changes and click Reboot button to activate.
Enable UPNP
Enable UPNP protocol on the access point.
• Service:
o Enable: Select to enable UPNP through the access point
o Disable: Select to disable UPNP
Backup / Restore and Reset to Factory
Backup current configuration, restore prior configuration or reset back to factory default
configuration can be executed via this page.
Please click on Utilities -> Profile Setting and follow the below setting.
Save Settings to PC: Click Save to save current access point configuration settings to
•
a computer.
Load Settings from PC: Click Browse button to locate a configuration file to restore,
•
and then click Upload button to upload.
•
Reset To Factory Default: Click Default button to reset back to the factory default
settings and expect Successful loading message. Then, click Reboot button to
activate.
TEW-738APBO
71
Advertisement
Table of Contents
