Table of Contents
Advertisement
TRENDnet User's Guide
Group Key Update Period: By default, it's 3600 seconds. This time interval for
o
rekeying GTK, broadcast/multicast encryption keys, in seconds. Entering the time-
length is required.
Master Key Update Period: By default, it is 83499 seconds. This time interval for
o
rekeying GTK, broadcast/multicast encryption keys, in seconds. Entering the time-
length is required.
EAP Reauth Period: By default, it's 3600 seconds. Set WPA2 PMKID cache
o
timeout period, after time out, the cached key will be deleted.
Pre-Authentication: By default, it's "Disable". To Enable is use to speed up
o
roaming before pre-authenticating IEEE 802.1X/EAP part of the full RSN
authentication and key handshake before actually associating with a new AP.
Radius Server Settings :
•
IP Address: Enter the IP address of the Authentication RADIUS server.
o
Port: By default, it's 1812. The port number used to communicate with RADIUS
o
server.
Shared secret: A secret key used between system and RADIUS server. Supports 8
o
to 64 characters.
Accounting RADIUS Server: Enable to set Account RADIUS server.
o
•
WEP 802.1X: When WEP 802.1x Authentication is enabled, please refer to the
following Dynamic WEP and RADIUS settings to complete configuration.
Radius Server Settings:
•
IP Address: Enter the IP address of the Authentication RADIUS server.
o
Port: By default, it's 1812. The port number used to communicate with RADIUS
o
server.
© Copyright 2014TRENDnet. All Rights Reserved.
Shared secret: A secret key used between system and RADIUS server. Supports 8
o
to 64 characters.
Accounting RADIUS Server: Enable to set Account RADIUS server.
o
Key Index: key index is used to designate the WEP key during data transmission.
o
4 different WEP keys can be entered at the same time, but only one is chosen.
WEP Key #: Enter HEX or ASCII format WEP key value; the system supports up to 4
o
sets of WEP keys.
WPA-PSK (or WPA2-PSK): WPA (or WPA2) Algorithms, allows the system accessing
o
the network by using the WPA-PSK protected access.
AP Setup
The administrator can configure station profiles via this page.
Please click on Wireless -> Wireless Profile and follow the below setting.
• ESSID: Assign Service Set ID for the wireless system.
• Enable Repeater SSID: Select Enable to broadcast the repeated signal.
• Hidden SSID: Select Enable to broadcast the access point's SSID.
• Client Isoltion: Select Enable to isolate wireless clients from each other.
• IAPP:
• Maximum Clients: Enter the amount of wireless clients allowed to connect to the
access point.
•
Security Type: Select the desired security type from the drop-down list; the options
are Disable, WEP, WPA-PSK, WPA2-PSK, WPA-Enterprise, WPA2-Enterprise and
WEP 802.1X.
Disable: Data are unencrypted during transmission when this option is selected.
o
TEW-738APBO
60
Advertisement
Table of Contents
