Table of Contents
Advertisement
TRENDnet User's Guide
Bridge table information: Select "Bridge Table information" on the drop-down list
•
to display bridge table. Bridge table will show Bridge ID and STP's Status on the
each Ethernet bridge and its attached interfaces, the Bridge Port should be
attached to some interfaces (e.g. eth2, ra0~ra6 and wds0~wds3).
Bridge MAC information: Select "Bridge MACs Information" on the drop-down list
•
to display MAC table.
This table displays local MAC addresses associated with wired or wireless interfaces,
but also remember non-local MAC addresses learned from wired or wireless
interfaces. Ageing timers will be reset when existing MAC addresses in table are
learned again or added when new MAC addresses are seen from wired or wireless
interfaces as well. When time runs out for a particular entry, it will be pruned from
the table. In that situation, switching packet to that particular MAC address will be
dropped.
© Copyright 2014TRENDnet. All Rights Reserved.
Event Log
The Event log displays system events when system is up and running. Also, it becomes
very useful as a troubleshooting tool when issues are experienced in system.
Time: The date and time when the event occurred.
•
Facility: It helps users to identify source of events such "System" or "User"
•
Severity: Severity level that a specific event is associated such as "info", "error",
•
"warning", etc.
Message: Description of the event.
•
Click Refresh button to renew the log, or click Clear button to clear all the record.
WDS Link Status
Peers MAC Address, antenna 0/1 received signal strength, phy mode and channel
bandwidth for each WDS are available.
o MAC Address: Display MAC address of WDS peer.
o RSSI: Indicate the signal strength of the respective WDS links.
TX/RX SEQ: Transmit and receive sequence.
o
TX/RX Bytes: Transmit and receive bytes
o
TEW-738APBO
34
Advertisement
Table of Contents
