Table of Contents
Advertisement
TRENDnet User's Guide
Routing
This section allows you to configure the routing of the access point.
OSPF: Select Enable to enable OSPF setting
•
RouterID: Select the ID to configure
•
•
Network (WAN): Select to configure the WAN section, enter the area to assign
Network (LAN): Select to configure the LAN section, enter the area to assign.
•
Distribute RIP over OSPF: Check this option to use RIP protocol
•
RIP Settings
•
•
RIP Service: Select Enable to use RIP protocol
Side: Select the network section to apply RIP.
•
Status
This section breaks down into subsections of System Overview, Associated Clients
Status, WDS Link Status, Extra Information and Event Log.
© Copyright 2014TRENDnet. All Rights Reserved.
System Overview
Display detailed information of System, Network, LAN and Wireless in the System
Overview page.
Device Information: Display the information of the system.
•
Operating Mode: The mode currently in service.
o
Host Name: The name of the system.
o
Host Description: A description of the system.
o
Firmware Version: The current installed firmware version.
o
Firmware Date: The build time of installed firmware.
o
Device Time: The current time of the system.
o
System Up Time: The time period that system has been in service since last
o
reboot.
ETH1/ETH2MAC: Ethernet MAC address of the access point.
o
Wireless MAC: Wireless MAC address of the access point
o
CPU Loading: The CPU loading of the access point
o
Memory Used: Memory usage of the access point.
o
TEW-738APBO
65
Advertisement
Table of Contents
